Left Side Impact Sensor 1 Internal 1 - Chrysler Pacifica 2004 Service Manual

Hide thumbs Also See for Pacifica 2004:

Table of Contents

LEFT SIDE IMPACT SENSOR 1 INTERNAL 1

When Monitored and Set Condition:

LEFT SIDE IMPACT SENSOR 1 INTERNAL 1

When Monitored: At ignition on, the Left Side Impact Sensor 1 is equipped with onboard

diagnostics to monitor the sensors internal circuits. If a problem is identified the sensor

sends the Left Side Impact Sensor 1 internal 1 message to the ACM.

Set Condition: The code will set, if the ACM receives an Impact Sensor Internal 1

message from the Left Side Impact Sensor 1.

ACM, LEFT SIDE IMPACT SENSOR 1

REPAIR IS COMPLETE

STORED CODE OR INTERMITTENT CONDITION

ACTIVE CODE PRESENT

Turn the ignition on.

NOTE: Ensure the battery is fully charged.

NOTE: For the purpose of this test, the AECM and ORC modules will be

referred to as an ACM.

SELECT ACTIVE or STORED DTC:

ACM - ACTIVE DTC

ACM - STORED DTC

NOTE: When reconnecting Airbag system components, the ignition must be

turned off and the battery must be disconnected.

Replace the Left Side Impact Sensor 1.

Reconnect the vehicle wire harness to the impact sensor.

Remove any special tools or jumper wires and reconnect all previously disconnected

components - except the Battery.

WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-

TION ON, THEN RECONNECT THE BATTERY.

Connect the DRB to the Data Link Connector - use the most current software

Use the DRB III and erase the stored codes in all airbag system modules.

Turn the Ignition Off, and wait 15 seconds before turning the Ignition On.

Wait one minute, and read active codes and if there are none present read the stored

DID the active Left Side Impact Sensor 1 DTC return?

Yes → Go To 3

→ Repair is complete.

POSSIBLE CAUSES

Perform __AIRBAG VERIFICATION TEST - VER 1.

APPLICABILITY