Table of Contents
Advertisement
Symptom:
CMTC MESSAGES NOT RECEIVED
When Monitored and Set Condition:
CMTC MESSAGES NOT RECEIVED
When Monitored: With the ignition in run.
Set Condition: The module does not receive any messages from the CMTC. Time to
mature for the BCM, DDM and PDM is 5 seconds. Time to mature for the IPM is 10
seconds.
ATTEMPT TO COMMUNICATE WITH THE CMTC
MODULE
TEST
1
Turn the ignition on.
With the DRBIII , attempt to communicate with the CMTC.
Was the DRBIII able to I/D or communicate with the CMTC?
Yes → Go To 2
→ Refer to the Communication category for the related symptom(s).
No
2
With the DRBIII , erase DTC's.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRBIII , read DTC's.
Did this DTC reset?
Yes → Replace the module which set the DTC in accordance with the
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
service information.
Perform BODY VERIFICATION TEST - VER 1.
305
COMMUNICATION
APPLICABILITY
All
All
Advertisement
Table of Contents
