Table of Contents
Advertisement
Symptom:
RUN ONLY RELAY SHORT TO BATTERY - IPM
When Monitored and Set Condition:
RUN ONLY RELAY SHORT TO BATTERY - IPM
When Monitored: Continuously..
Set Condition: The output is on and a short to battery condition exists. The code will set
in 1 second.
DTC PRESENT
RUN ONLY RELAY
IPM
TEST
1
Turn the ignition on.
With the DRBIII , erase DTCs.
Turn the ignition off, wait 30 seconds, then turn the ignition on.
With the DRBIII , read DTCs.
Does the DRBIII display: RUN ONLY RELAY SHORT TO BATTERY?
Yes → Go To 2
→ The condition that caused the symptom is not currently present.
No
2
Turn the ignition off.
Install a substitute relay in place of the existing Run Relay.
With the DRBIII , erase DTCs.
Turn the ignition on.
With the DRBIII , read DTCs.
Does the DRBIII display: RUN ONLY RELAY SHORT TO BATTERY?
Yes → Replace the IPM in accordance with the Service Information.
→ Replace the Run Relay.
No
POSSIBLE CAUSES
ACTION
Refer to any Technical Service Bulletins (TSBs) that may apply.
Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
IGNITION, POWER, ACCESSORY
607
APPLICABILITY
All
All
Advertisement
Table of Contents
