Table of Contents
Advertisement
GENERAL INFORMATION
3.5.3 WARNING LAMP ANNOUNCEMENT
Low Fuel Lamp:
The cluster will sound a single chime and display
an EVIC warning message after illuminating the
indicator.
Volt Lamp:
The cluster will sound a single chime after illumi-
nating the indicator.
Oil Pressure Lamp:
The cluster will sound a single chime after illumi-
nating the indicator above 450-rpm.
Fasten Seat Belt Lamp:
There are two different Fasten Seat Belt Reminder
announcements incorporated into the MIC's logic,
a Non-enhanced announcement and an Enhanced
announcement.
When the Enhanced announcement is DISABLED,
the Fasten Seat Belt Reminder operates as follows:
•
The BCM will request the MIC to chime five
times and illuminate the Seat Belt Lamp after
turning the ignition to the run/start position if
the driver seat belt is unbuckled.
When the Enhanced announcement is ENABLED,
the Fasten Seat Belt Reminder operates as follows:
•
The BCM will request the MIC to chime contin-
uously at a slow rate for a period of 6 seconds and
illuminate the Seat Belt Lamp after turning the
ignition to the run/start position if the driver
seat belt is unbuckled. After 6 seconds the chime
will stop, but the Seat Belt Lamp will stay
illuminated. If the ignition is in the run position
for a period greater than 70 seconds, and the
driver seat belt is unbuckled, and the vehicle's
speed is greater than 5 mph (8 km/h) in a
forward gear, the Enhanced Fasten Seat Belt
Reminder will activate. This will cause the Seat
Belt Lamp to blink and a slow continuous chime
to sound for 5 seconds. After 5 seconds, the chime
will stop, but the lamp will remain illuminated
for an additional 3 seconds. The Enhanced Seat
Belt Reminder cycles for a total of 12 times (96
seconds). After the 12th time, the Seat Belt
Lamp will remain on without any chime. Buck-
ling the driver seat belt at anytime will cancel
the Fasten Seat Belt Reminder announcement.
Check Engine Lamp:
The cluster will sound a single chime after illumi-
nating the indicator.
Engine Temperature Lamp:
The cluster will sound a single chime when the
indicator first illuminates at 252°F (122°C).
Traction control Lamp:
The cluster will sound a chime and display an
EVIC warning message after illuminating the in-
dicator if the traction control system:
•
Is active.
•
Is suspended.
•
Needs service.
•
Is disabled by the driver.
Turn Signal On:
If the BCM detects a turn signal input continu-
ously for 1.0 mile (0.6 km) and the vehicle speed is
greater than 15 mph (24 km/h), the cluster will
chime continuously and display an EVIC warning
message, until the turn signal is cancelled.
3.5.4 OTHER CHIME ON CONDITIONS
Bulb Check:
The chime will sound one time during bulb check.
Brake Lamp:
The cluster will sound a chime and display an
EVIC warning message if the:
•
Park brake is engaged and the vehicle speed
exceeds 1 mph (1.61 km/h).
•
Brake fluid is low.
Memory:
The cluster will sound a chime and display an
EVIC message when:
•
Memory position #1 is set.
•
Memory position #2 is set.
•
The vehicle is out of park and a memory recall is
selected.
•
A memory recall is activated while the seat is in
motion during another memory recall.
Service:
The cluster will sound a chime and display an
EVIC message when the vehicle reaches the time
to perform service.
RKE:
The cluster will sound a chime and display an
EVIC message upon activation of:
•
The key fob with a low battery.
•
An invalid key fob and key.
Immobilizer:
The cluster will sound a chime and display an
EVIC message when there is a problem with the
SKREEM Module.
Power Liftgate:
The cluster will sound a chime and display an
12
Advertisement
Table of Contents
