Analog Output Signal Setup; Table 5-1: Analog Output Signal Selection - Emerson Rosemount Xstream Series Instruction Manual

Instruction Manual
HASAxE-IM-HS
05/2006
5-4-3-4-1-1

Analog Output Signal Setup

Signal:
Enter this line to select which values to output
via the analog outputs.
Available options are:
Option
C1-C2
C1-T
T-C2
20 mA
0 / 4 mA A signal is applied to both analog outputs
*) Select one of these modes only to do a quick
check if the analog output level settings are still
correct.
Emerson Process Management GmbH & Co. OHG
5-4 Menu System - Analog Output Setup Menu
C1-C2
Output 1
Channel 1 gas
concentration
Channel 1 gas
concentration
Temperature sensor
"Temp-1" value
A signal is applied to both analog outputs
creating a 20 mA output signal
creating an output signal of 0 mA (when in
Dead-Zero mode) or 4 mA when in Life-
Zero mode.
Dead-Zero or Live-Zero mode is selected
by the "Signal range" parameter
( 5-4-3-4-1-2, page 5-36)

Table 5-1: Analog Output Signal Selection

Output 2
Channel 2 gas
concentration
Temperature sensor
"Temp-1" value
Channel 2 gas
concentration
X-STREAM
Operational
Modes
Modes for
checking the
output signal
adjustments
only *)
5-35