Subaru Legacy 2005 Service Manual page 3702

SEAT BELT SYSTEM
5. Front Seat Belt
A: REMOVAL
1. OUTER SEAT BELT ASSEMBLY
CAUTION:
• Do not drop or apply any impact to the seat
belt pretensioner.
• Since the seat belt pretensioner and bracket
are integrated as a unit, do not disassemble
them.
1) Turn the ignition switch to OFF, disconnect the
battery ground terminal, and wait more than 20
seconds.
2) Fold the backrest all the way forward, and then
move the front seat all the way forward.
3) Remove the center pillar lower trim. <Ref. to EI-
60, REMOVAL, Lower Inner Trim.>
4) Remove the center pillar upper trim. <Ref. to EI-
62, REMOVAL, Upper Inner Trim.>
5) Remove the bolt, and remove the center pillar in-
ner protector lower.
6) Remove the bolt, and then remove the shoulder
anchor.
Front Seat Belt
7) Remove the bolt, and then remove the adjust-
able anchor assembly.
8) Disconnect the seat belt pretensioner connector
(A).
NOTE:
Disconnect the tension reducer connector (B) for
the seat belt retractor with tension reducer function.
9) Pull off the floor mat to remove the bolt.
SB-00144
10) Disconnect the orange connector of lap seat
belt pretensioner harness to remove outer seat belt
assembly.
2. INNER SEAT BELT ASSEMBLY
SB-00152
1) Turn the ignition switch to OFF, disconnect the
battery ground terminal, and wait more than 20
seconds.
2) Remove the console box. <Ref. to EI-53, RE-
MOVAL, Console Box.>
3) Disconnect the seat belt warning light connector
under the seat.
4) Remove the harness clips from slide rail.
SB-14
(B)
(A)
SB-00153
SB-00298
SB-00299