Subaru Legacy 2005 Service Manual page 4144

LAN SYSTEM (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
NOTE:
• DTC is displayed in the sequence of inputting.
(When inputting two DTCs or more simultaneously,
they are displayed in the sequence of priority.)
• When two DTCs or more are displayed, perform
the diagnosis of top of them.
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to LAN(diag)-6, SPECIAL TOOL, PREPARA-
TION TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
Data link connector is located in the lower portion of
instrument panel (on the driver's side).
Subaru Select Monitor
CAUTION:
Do not connect the scan tools except Subaru
Select Monitor.
5) Turn the ignition switch to ON (engine OFF), and
turn the Subaru Select Monitor power switch to ON.
6) On the "Main Menu" display screen, select the
{Each System Check} and press the [YES] key.
7) On the "System Selection Menu" display screen,
select the {Integ. unit mode} and press the [YES]
key.
LAN00014
8) On the "Integ. unit mode failure diag" display
screen, select the {Diagnostic Code(s) Display}
and press the [YES] key.
NOTE:
• For details concerning operation procedure, re-
fer to the SUBARU SELECT MONITOR OPERA-
TION MANUAL.
• For details concerning DTCs, refer to the List of
Diagnostic Trouble Code (DTC). <Ref. to LAN(di-
ag)-28, List of Diagnostic Trouble Code (DTC).>
EN-00039
LAN00110
LAN(diag)-14
(A) Power switch
(A)
LAN00017