Subaru Legacy 2005 Service Manual page 3945

5. Sunroof Motor
A: REMOVAL
CAUTION:
• When removing the clip, use great care not to
damage the roof trim.
• Never rotate the sunroof motor after remov-
ing it.
1. SEDAN MODEL
1) Completely close the glass lid.
2) Disconnect the ground cable from battery.
3) Remove the spot map light. <Ref. to LI-34, RE-
MOVAL, Spot Map Light.>
4) Disconnect the harness connector, loosen the
®
TORX bolts, and then remove the motor assem-
bly.
CAUTION:
When removing the motor assembly, secure
the cable wires to prevent moves.
2. WAGON MODEL
1) Fully close the glass lid (front) and glass lid
(rear).
2) Disconnect the ground cable from battery.
3) Remove the luggage room light. <Ref. to LI-36,
REMOVAL, Luggage Room Light.>
4) Remove the roof trim. <Ref. to EI-67, WAGON
MODEL, REMOVAL, Roof Trim.>
Sunroof Motor
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
5) Pass the seat belt tongue located on center of
rear seat through the hole, and then pull it out to the
opposite side of trim.
6) Remove the clips, and then drop the rear end of
roof trim.
7) Disconnect the harness connector (A), and then
remove the motor assembly mounting bolt (B) and
nuts (C).
SR-00121
B: INSTALLATION
CAUTION:
When installing the motor assembly, be careful
not to move the sunroof cable.
SR-11
(B)
(A)
(A) Tongue
(B) Cover
(C)
(A)
(B)
(C)
SR-00036
SR-00089