Table of Contents
Advertisement
GLASS/WINDOWS/MIRRORS
B: INSTALLATION
1) Clean the external circumference of windshield
glass with alcohol or white gasoline.
2) Remove the adhesive layer on the body using
cutter knife to obtain a smooth face of 2 mm (0.08
in) thick.
CAUTION:
Be careful not to damage the body and paint
surface.
(1)
(1) Adhesive
(2) 2 mm (0.08 in)
(3) Dam rubber
(4) Glass
3) Clean the body with alcohol or white gasoline to
eliminate cutting powder, dust and dirt completely
from body.
4) Install the dam rubber.
5) Fit the mark (B) on molding to the notch (A) of
glass side, and install the molding to entire perime-
ter of glass.
Windshield Glass
(3)
(2)
(4)
GW-00071
(A)
(B)
GW-00316
6) Apply two types of primers to the adhesive layer
of glass using sponge.
Glass primer:
Dow Automotive's
Betawipe VP 04604
Betaprime 5001
7) Apply primer to the adhesive layer of body.
Painted surface primer:
Dow Automotive's
Betaprime 5402
NOTE:
• Primer once attached to the painted surface of
the body and internal trim is hard to wipe off. Mask
the circumference of such area.
• Let primer dry for about ten minutes before in-
stalling glass.
• Do not touch the surface coated with primer.
(2)
(1) Primer application surface
(2) Glass side
(3) Body side
8) Cut off the cartridge nozzle tip as shown and set
it in sealant gun.
(1) 10 mm (0.39 in)
(2) 15 mm (0.59 in)
GW-28
(1)
(3)
GW-00073
(1)
(2)
GW-00238
Advertisement
Chapters
Table of Contents
