Subaru Legacy 2005 Service Manual page 4022

EXTERIOR/INTERIOR TRIM
31.Rear Shelf Trim
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear quarter trim. <Ref. to EI-63,
SEDAN MODEL (MODEL WITH CURTAIN AIR-
BAG), REMOVAL, Rear Quarter Trim.>
3) Remove the high-mounted stop light. <Ref. to LI-
33, REMOVAL, High-mounted Stop Light.>
4) Remove the rear seat cushion. <Ref. to SE-14,
WAGON MODEL, REMOVAL, Rear Seat.>
5) Remove the lower anchor bolt of rear center seat
belt.
6) Disconnect the high-mounted stop light harness
connector (A), remove the five clips, and then re-
move the rear shelf trim with pulling it frontward.
Rear Shelf Trim
EI-00675
(A)
EI-00676
EI-70
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Securely insert the vehicle body panel into the hook
of rear shelf trim center to install the rear shelf trim.
(1)
(1) Hook
(2) Rear shelf trim
(3) Vehicle body panel
(2)
(3)
EI-00739