Table of Contents
Advertisement
9) Apply adhesive to the glass end surface as
shown.
Adhesive:
Dow Automotive's
Gurit-ESSEX Betaseal 1502 or equivalent
(1) 9 — 12 mm (0.35 — 0.47 in)
10) Fit the locating pins using suction rubber cup to
install windshield glass.
11) Lightly press the windshield glass for tight fit.
12) Make flush the adhesive surface jutted out us-
ing spatula.
13) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When the door is opened/closed after glass
bonded, always lower the door glass and then
open/close it carefully.
• Move the vehicle slowly.
• For minimum time for drying after bonding and
leaving vehicle before driving, follow instructions or
instruction manual from the manufacturer of adhe-
sive.
14) After curing of adhesive, pour water on the ex-
ternal surface of vehicle to check that there are no
water leaks.
NOTE:
When returning the vehicle to the owner, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
15) Install the cowl panel. <Ref. to EI-39, INSTAL-
LATION, Cowl Panel.>
Windshield Glass
(1)
GW-00239
GW-00045
GW-29
GLASS/WINDOWS/MIRRORS
Advertisement
Chapters
Table of Contents
