Subaru Legacy 2005 Service Manual page 3420

POWER ASSISTED SYSTEM (POWER STEERING)
10) Disassemble the oil pump and bracket by in-
serting a flat tip screwdriver as shown in the figure.
2. H6 MODEL
1) Disconnect the ground cable from battery.
2) Remove the cover of pully belt.
3) Remove the V-belt.
4) Remove the power steering pressure switch
connector.
5) Remove the tensioner adjuster.
6) Disconnect the pressure hose and suction hose
from the oil pump.
CAUTION:
• Do not allow fluid to flow from the hose end
and to contact pully belt.
• To prevent entering foreign matter into hose,
cover the hose opening with clean cloth.
(1)
(2)
(1) Suction hose
(2) Pressure hose
7) Remove the bolts which install power steering
pump bracket.
Oil Pump
8) Place the oil pump bracket in a vise, and remove
the two bolts from the front side of oil pump.
CAUTION:
When securing the oil pump bracket in a vise,
hold the oil pump bracket with the least possi-
ble force between two wood pieces.
PS-00129
9) Remove the bolt from back side of oil pump.
10) Remove the oil pump from bracket.
PS-00700
PS-00701
PS-82
PS-00229
PS-00702