Control Panel (Auto A/C Model)
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
12.Control Panel (Auto A/C Mod-
el)
A: REMOVAL
1) Remove the audio assembly. <Ref. to ET-5, RE-
MOVAL, Audio.>
2) Remove the six screws.
NOTE:
When working the removed audio assembly with its
back facing down, place wooden blocks between
the audio assembly and the workbench to prevent
ground terminal from folding.
AC-01135
3) Using a fine flat tip screwdriver, remove the ten
hooks gradually in the order of both sides, lower
and upper side.
: (A)
AC-01136
(A) Hook
4) Pull the panel straight toward you to remove.
CAUTION:
Be careful not to touch the logic board to pre-
vent static electricity damage.
B: INSTALLATION
1) Fit the hooks. Make sure the firm connection be-
tween logic board and connector by pushing the
center part of panel with fingertips.
2) Install in the reverse order of removal.
AC-31