Subaru Legacy 2005 Service Manual page 3325

15.Stop Light Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the stop light switch connector.
3) Loosen the nuts, unscrew the stop light switch,
and remove stop light switch.
(1) Stop light switch
B: INSTALLATION
1) Screw the stop light switch onto a bracket and
secure it temporarily with a nut.
2) Adjust the stop light switch position, and then
tighten the nut.
<Ref. to BR-46, ADJUSTMENT, Stop Light
Switch.>
Tightening torque:
⋅
8 N m (0.8 kgf-m, 5.8 ft-lb)
Stop Light Switch
(1)
BR-00107
T
BR-00108
BR-45
C: INSPECTION
1) If the stop light switch does not operate properly
(or if it does not fix at the specified position), re-
place with a new one.
Specified position L:
2 mm (0.079 in)
L
2) Measure the clearance between the threaded
end of stop light switch and stopper.
CAUTION:
Be careful not to rotate the stop light switch.
Stop light switch clearance A:
0.3 mm (0.012 in)
(1) Stop light switch
(2) Stopper
(3) Brake pedal
3) If it is not within the specification, adjust it by ad-
justing the position of stop light switch.
CAUTION:
Be careful not to rotate the stop light switch.
BRAKE
BR-00109
(1)
A
(2)
(3)
BR-00110