Subaru Legacy 2005 Service Manual page 4149

6) Change the setting with UP/DOWN key and press the [YES] key.
• List of body integrated module registration item
NOTE:
Setting is different depending on grade of vehicle.
Data
A/C ECM setting
P/W ECM setting
Center display failure (OP)
Wiperdeicer (OP)
Rear fog light setting (OP)
Factory initial setting (Reset of body
integrated module)
CAUTION:
• It is possible to control the original functions of vehicle when registrations of body integrated mod-
ule and function setting are corresponded to vehicle equipment.
• When body integrated module is new one or "Factory" mode, key illumination blinks to show
equipment settings does not completed.
• Be sure not to change Factory initial setting except installation of new body integrated module.
NOTE:
"Factory" mode:
• Body integrated module has not been set yet. It can be recognized by key illumination blinking with ignition
switch turned to ON.
• All body integrated modules as part for repair are set to "Factory" mode. When replacing a body integrated
module, be sure to perform the registration operation.
"Market" mode:
• Each settings of body integrated module have been set. It can be recognized by key ring illumination op-
erating simultaneously with room light and turning off with ignition switch turned to ON.
Subaru Select Monitor
Initial set-
Registration
ting
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
Factory (Reset)
Factory
Market (Settle-
ment)
LAN(diag)-19
LAN SYSTEM (DIAGNOSTICS)
Remarks
Illumination control does not operate if A/C ECM setting
is set to "OFF" in case of model with auto A/C.
If A/C ECM setting is set to "ON" in case of model with-
out auto A/C, illumination change to night illumination
and it is difficult to be recognized.
Be sure to set P/W ECM setting to "OFF".
Information may not be displayed on center display if
Center display failure is set to "OFF" in case of model
with center display.
ON signal does not output with operation of wiper
deicer switch if Wiperdeicer is set to "OFF" in model
with wiper deicer.
Vehicle is controlled in rear fog light equipped mode.
Vehicle is controlled in rear fog light no-equipped mode.
(Be sure to set to "OFF" in model without rear fog light.)
If Factory initial setting is set to "Factory", registrations
of items above is changed to "OFF". Be sure to set to
"Market".