Subaru Legacy 2005 Service Manual page 3941

B: INSTALLATION
Install in the reverse order of removal.
C: ADJUSTMENT
1. SEDAN MODEL
Loosen the glass lid mounting TORX
and then adjust the height on lid side.
Difference in height between glass lid and roof
panel L:
± ±
2.0 1.0 mm (0.079
2. WAGON MODEL
Loosen the glass lid installation nuts, and then ad-
just the height by adding (max: four pieces) or ex-
tracting (min: zero piece) shims (B) (standard: two
pieces) which installed between glass lid (A) and
body.
®
bolts (A),
0.039 in)
(A)
L
SR-00124
Glass Lid
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
Difference in height between glass lid and roof
panel L:
±
2.0 1.0 mm (0.079
D: FORCED DRIVE
If glass lid dose not operate or is not supplied with
power, move the glass lid using the emergency
handle (hex wrench)*.
*: Emergency handle (L shape general purpose
hexagon wrench)
Sedan model: bolt width 4 mm (0.16 in)
Wagon model: bolt width 5 mm (0.20 in)
1. SEDAN MODEL
1) Remove the spot map light. <Ref. to LI-34, RE-
MOVAL, Spot Map Light.>
2) Insert the hex wrench securely until it touches
the motor shaft edge.
3) Turn the hex wrench, and move the glass lid.
• Turning right, the glass lid open.
• Turning left, the glass lid close.
SR-7
±
0.039 in)
(B)
(B)
L
(A)
SR-00077
SR-00099