Subaru Legacy 2005 Service Manual page 3394

POWER ASSISTED SYSTEM (POWER STEERING)
5) Insert the ST-A with oil seal assembled from the
gear side of rack. Remove the oil seal from ST-A
near piston, and then remove the ST-A from rack.
(C)
(B)
(A) Oil seal
(B) Rack
(C) Piston
6) Install the back-up washer from the gear side of
rack.
(1) Oil seal
(2) Back-up washer
(3) Rack
Steering Gearbox [RHD Model]
ST A
(A)
PS-00076
PS-00077
7) Install the ST on rack, equally apply a thin coat of
grease to the rack and ST, and then install the oil
seal.
ST 926250000
CAUTION:
Be careful not to scratch the oil seal lips with
the inner ring section of piston.
NOTE:
Do not use this ST for turbo model.
(1) Rack piston inner ring
(2) Outer side oil seal
(3) Rack
8) Apply a coat of grease to the grooves in rack,
sliding surface of sleeve and sealing surface of pis-
ton. Install ST on the end of steering body cylinder.
Then insert the rack into steering body from cylin-
der side.
ST 34199FE050 GUIDE (Turbo and 3.0 R mod-
ST 34199AE000 GUIDE (Except for turbo and
CAUTION:
Do not allow grease to block the air vent hole on
rack.
(1) Cylinder side of steering body
(2) Air vent hole
(3) Oil seal
(4) Rack
PS-56
GUIDE
PS-00078
el)
3.0 R model)
PS-00079