Table of Contents
Advertisement
5) Using a flat tip screwdriver, remove the band
from boot.
NOTE:
Replace the boot if there is damage, cracks or de-
terioration.
(1)
(1) Band
6) Using the ST, loosen the lock nut.
ST 926230000
SPANNER
(1)
(1) Lock nut
7) Tighten the adjusting screw until it no longer
tightens.
(1) Adjusting screw
Steering Gearbox [RHD Model]
PS-00493
ST
PS-00494
(1)
PS-00495
POWER ASSISTED SYSTEM (POWER STEERING)
8) Using a 32 mm spanner or adjustable wrench
with cinching boot, remove the tie-rod.
(1) Tie-rod
9) Loosen the adjusting screw and remove the
spring and sleeve.
10) Clean the dirt adherent to the input shaft. Re-
move the dust cover paying attention not to scratch
the housing or input shaft and not to allow foreign
matter to enter the gear box interior.
CAUTION:
Wrap the tape to the spline part of input shaft to
avoid damaging dust cover.
(1) Dust cover
PS-51
PS-00058
(1)
PS-00497
Advertisement
Chapters
Table of Contents
