Subaru Legacy 2005 Service Manual page 3602

AIRBAG SYSTEM (DIAGNOSTICS)
8. Read Diagnostic Trouble
Code (DTC)
A: OPERATION
1) Remove the instrument panel lower cover under.
2) Disconnect the ground terminal harness from
check connector harness on the side of heater unit.
NOTE:
The harness (black) of ground terminal is wrapped
by tapes with the harness of check connector.
3) Turn the ignition switch to ON.
4) Connect one of the ground terminals to the
check connector terminal No. 2.
1 2 3
8 9 10
CAUTION:
Do not connect the ground terminal to the con-
nector except for the check connector terminal
No. 2.
5) Read the DTC by identifying the blinking pattern
of airbag warning light.
The airbag warning light blinks a DTC correspond-
ing to the faulty parts.
The long segment (1.2 sec. on) indicates a "two -
digit", and the short segment (0.3 sec. on) indicates
a "one-digit".
NOTE:
• "List of Diagnostic Trouble Code (DTC)" <Ref. to
AB(diag)-38, List of Diagnostic Trouble Code
(DTC).>
• "Airbag Warning Light Failure" <Ref. to AB(diag)-
34, Airbag Warning Light Failure.>.
Read Diagnostic Trouble Code (DTC)
AB-01199
4 5 6 7
11 12 13 14
AB-00847
AB(diag)-30