Subaru Legacy 2005 Service Manual page 3815

5) To adjust the upper end and lower end of center
pillar, loosen the stopper bolt (A) or nut (B) securing
door sash (front, rear), and move the stopper until
each clearance from center pillar cover becomes
equal.
CAUTION:
Measure the clearance from center pillar at
more than 50 mm (1.969 in) apart from the up-
per end of window glass.
(1)
(1) Glass
(2) Center pillar cover
(3) Measuring point
(4) 50 mm (1.969 in)
(5) 11 mm (0.433 in)
Front Door Glass
(A)
GW-00320
(B)
GW-00321
(2)
(5)
(4)
(3)
GW-00322
GW-13
GLASS/WINDOWS/MIRRORS
6) Adjust so that the clearances at upper and lower
ends of center pillar are equal.
(A)
(3)
(B)
(3)
(A) Glass tilts too far rearward
(B) Glass tilts too far forward
(1) Narrow
(2) Wide
(3) Stopper adjusting direction
(1)
(2)
(3)
(2)
(1)
(3)
GW-00440