Table of Contents
Advertisement
GLASS/WINDOWS/MIRRORS
11) Remove the door glass.
CAUTION:
• Since the gear may be disengaged, do not
turn regulator in the closing direction after re-
moving glass.
• Avoid impact and damage to the glass.
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure that glass stay is placed securely in
sash.
2) Adjust the front door glass. <Ref. to GW-12, AD-
JUSTMENT, Front Door Glass.>
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to GW-4, FRONT DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
Before performing adjustment, ensure that all the
adjusting bolts of stabilizer, upper stopper and sash
are loose, and the door glass can be raised until it
contact with weather strip.
1) Temporarily tighten the adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten the regulator B channel at
the top position of slotted hole.
Front Door Glass
3) Lower the door glass 10 — 15 mm (0.39 — 0.59
in) from fully closed position. While applying an out-
ward pressure of 45.0±5.0 N (4.5±0.5 kgf, 9.9±1.1
lbf) F to the upper edge of glass above midpoint of
two outer stabilizers, press the inner stabilizer to
the glass at a pressure of 25±5 N (2.5±0.5 kgf,
5.5±1.1 lbf) to secure it.
GW-00267
4) To adjust the clearance between front glass and
center pillar cover, loosen the nuts (A), and move
the glass sash back and forward until clearance be-
comes the value shown.
GW-12
(1)
A
A
(2)
A = A
(1) Fully closed position
(2) Stabilizer
(3) 20 — 25 mm (0.78 — 0.98 in)
(2)
(1)
(3)
(1) Adjust the lines parallel
(2) Sash
(3) Inner panel
(1)
A
A
(1) 11 mm (0.433 in)
F
(3)
(2)
GW-00063
(A)
GW-00319
(1)
A-A
GW-00064
Advertisement
Chapters
Table of Contents
