Table of Contents
Advertisement
9) Make the ST2 pass through rack, and then
press-in the rack and ST2 using press.
Press-in the rack until ST1 comes in contact with
ST2 and the edge surface of rack is aligned with
that of ST2.
ST1 34199FE050 GUIDE (Turbo and 3.0 R mod-
el)
ST1 34199AE000 GUIDE (Except for turbo and
3.0 R model)
ST2 34199FE060 INSTALLER (Turbo and 3.0 R
model)
ST2 34199AE010 INSTALLER (Except for turbo
and 3.0 R model)
ST1
(1) Outer side oil seal
(2) Rack piston
(3) Inner side oil seal
10) Install a new holder to the cylinder side of steer-
ing body.
Tightening torque:
⋅
75 N
m (7.6 kgf-m, 55.3 ft-lb)
Steering Gearbox [RHD Model]
ST2
(1)
(2)
(3)
PS-00431
PS-00498
PS-57
POWER ASSISTED SYSTEM (POWER STEERING)
11) Using the ST, caulk the steering body at one
point less than 3 mm (0.12 in) from holder.
CAUTION:
Be careful not to deform the holder.
ST 34099FA060 PUNCH HOLDER
ST
(A) Holder
(B) 3 mm (0.12 in)
12) Roll the vinyl tape on serration part of valve as-
sembly, and then apply grease on the tape surface.
(1) Vinyl tape
(A)
(B)
ST
PS-00084
PS-00085
Advertisement
Chapters
Table of Contents
