Table of Contents
Advertisement
2. Front Seat
A: REMOVAL
CAUTION:
The airbag system is fitted with a backup power
source. After disconnecting the battery ground
cable, the airbag may deploy if you do not wait
for 20 seconds before starting the repair of air-
bag system.
1) Remove the headrest with headrest lock button
depressed.
2) Tilt forward the backrest, and slide the seat for-
ward.
3) Remove the rear bolt cover, and remove the two
bolts at the rear side of slide rail.
4) Slide the seat backward, and remove the two
bolts at the front side of slide rail.
5) Remove the battery ground cable, and wait for
more than 20 seconds before starting work.
6) Disconnect the connector under the seat.
• Seat belt warning light connector (Driver's side).
• Side airbag connector (Model with side airbag)
• Seat heater connector (Model with seat heater)
• Power seat connector (Model with power seat)
7) Remove the seat from vehicle.
Front Seat
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Tighten the slide rail installing bolt gradually in sev-
eral steps to the specified torque in the order as
shown in the figure.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-2, COMPONENT, General
Description.>
SE-00003
C: DISASSEMBLY
1. MANUAL SEAT
1) Remove the seat from vehicle. <Ref. to SE-7,
REMOVAL, Front Seat.>
2) Remove the seat lifter cover using a flat tip
screwdriver, and loosen the inner bolt to remove
seat lifter lever.
3) Remove the hook (A) and detach reclining lever
cover.
SE-00474
SE-7
(4)
(1)
(2)
(3)
(A)
SEATS
SE-00479
SE-00290
SE-00404
Advertisement
Chapters
Table of Contents
