Installing The Fraction Collector - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
AFC-3000 Automated Fraction Collector

3.3 Installing the Fraction Collector

The AFC-3000 is designed for easy installation consisting of two parts; assembling the
fraction collector and connecting it to the analytical instrument.
For the most part, you can install the AFC-3000 without using tools. In fact, using tools such
as screwdrivers or pliers to perform most installation tasks may result in a damaged or
unusable instrument. You can remove the knurled screws with tools if necessary, but do not
tighten them with anything other than your fingers.
To install the fraction collector, you must complete the following tasks (each of these tasks
will be discussed in detail later in this section):
• Mount the diverter valve assembly (→ page 27)
• Establish connections on the diverter valve (→ page 28)
• Attach the rinse station (→ page 29)
• Connect the rinse station tubing (→ page 29)
• Check the proper alignment of the universal drip tray
• Place the fraction tube racks on the tray (→ page 30)
• Set the drop former height adjustment (→ page 33)
• Establish external connections (→ page 35)
• Set up the fraction collector in Chromeleon (→ page 39)
Important:
Important:
Page 26
Ensure that the power is off before proceeding with installation.
Assurez-vous que l'alimentation secteur est éteint avant de procéder
à l'installation.
Operating Instructions