Installation Of Input Plate Options - Danfoss VLT AQUA Drive FC 202 Design Manual

Selection
The ordering numbers and heights for the pedestals are
shown in Table 3.16
Frame Size Part Number
D1h 176F3631
D2h 176F3632
D5h/D6h 176F3452
D7h/D8h Included with unit Included with unit
E1 Included with unit Included with unit
Table 3.16 Pedestal Ordering Information

3.2.4 Installation of Input Plate Options

This section is for the field installation of input option kits for E-frame frequency converters.
Do not attempt to remove RFI filters from input plates. Removal of RFI filters from the input plates can cause damage.
NOTICE
Where RFI filters are available, there are two different types of RFI filters depending on the input plate combination and
the RFI filters interchangeable. Field installable kits in certain cases are the same for all voltages.
380-480 V [kW]
380-500 V [kW]
E1 FC102/FC202: 315
FC302: 250
FC102/FC202: 355–450
FC302: 315–400
Table 3.17 Input Options
525-690 V [kW]
E1 FC102/FC202: 450-500
FC302: 355-400
FC102/FC202: 560–630
FC302: 500–560
Table 3.18 Input Options
NOTICE
For further information, see the Instruction Sheet,
175R5795
MG20Z202
Design Guide
Instruction Number Height
[mm]
177R0452 400
177R0453 400
177R0500 200
200
200
Fuses Disconnect Fuses
176F0253 176F0255
176F0254 176F0256
Fuses Disconnect Fuses
176F0253 176F0255
176F0254 176F0258
Danfoss A/S © Rev. 06/2014 All rights reserved.
Illustration 3.17 Mounting of the Frequency Converter to the
Pedestal
RFI RFI Fuses
176F0257 176F0258
176F0257 176F0259
RFI RFI Fuses
Not Applicable Not Applicable
Not Applicable Not Applicable
3 3
RFI Disconnect
Fuses
176F0260
176F0262
RFI Disconnect
Fuses
Not Applicable
Not Applicable
53