Danfoss VLT AQUA Drive FC 202 Design Manual page 124

How to Install
NOTICE
Power connections can be made to positions A or B.
Frame size
E2
Table 5.13 Power Connections, E2
NOTICE
5 5
The F-Frames have 4 different sizes - F1, F2, F3 and F4. The F1 and F2 consist of an inverter cabinet on the right and
rectifier cabinet on the left. The F3 and F4 are F1 and F2 units, respectively, with an additional options cabinet to the
left of the rectifier.
Terminal Locations - Frame Sizes F1 and F3
Take the following position of the terminals into consideration when designing the cable access.
1 Front Side
2 Left Side
3 Right Side
Illustration 5.82 Terminal Locations - Inverter Cabinet - F1 and F3. Gland Plate is 42 mm below .0 Level.
122
Design Guide
Unit type
250/315 kW (400 V) and
355/450-500/630 KW (690 V)
315/355-400/450 kW (400 V)
1
6
Danfoss A/S © Rev. 06/2014 All rights reserved.
Dimension for disconnect terminal
A B C
381 (15.0) 245 (9.6) 334 (13.1)
383 (15.1) 244 (9.6) 334 (13.1)
2
308.3 [12.1]
253.1 [10.0]
180.3 [7.1]
.0 [.0]
44.40 [1.75]
244.40 [9.62]
4 Ground bar
5 Motor Terminals
6 Brake Terminals
D E
423 (16.7) 256 (10.1)
424 (16.7) 109 (4.3)
4
5
4
F
N/A
149 (5.8)
3
MG20Z202