3.2
Default values and ranges
See
Section C.1
parameters.
3.3
Disable write-protection on the transmitter
configuration
ProLink III
Field Communicator Configure > Manual Setup > Info Parameters > Transmitter Info > Write Protect
Overview
If the transmitter is write-protected, the configuration is locked and you must unlock it
before you can change any configuration parameters. By default, the transmitter is not
write-protected.
Tip
Write-protecting the transmitter prevents accidental changes to configuration. It does not prevent
normal operational use. You can always disable write-protection, perform any required configuration
changes, then re-enable write-protection.
3.4
Restore the factory configuration
ProLink III
Field Communicator Service Tools > Maintenance > Reset/Restore > Restore Factory Configuration
Overview
Restoring the factory configuration returns the transmitter to a known operational
configuration. This may be useful if you experience problems during configuration.
Important
You cannot restore factory configurations with a 700 core.
Tip
Restoring the factory configuration is not a common action. You may want to contact customer
support to see if there is a preferred method to resolve any issues.
Configuration and Use Manual
to view the default values and ranges for the most commonly used
Device Tools > Configuration > Write-Protection
Device Tools > Configuration Transfer > Restore Factory Configuration
Introduction to configuration and commissioning
15