Configure Density Cutoff; Configure Temperature Measurement; Configure Temperature Measurement Unit - Emerson Micro Motion 2500 Configuration And Use Manual

Configure process measurement
4.5.4

Configure Density Cutoff

Density Cutoff specifies the lowest density value that will be reported as measured. All
density values below this cutoff will be reported as 0.
Procedure
Set Density Cutoff to the value you want to use.
For most applications, the default setting (0.2 g/cm³) is sufficient. The range is 0.0 g/cm³
to 0.5 g/cm³.
Effect of Density Cutoff on volume measurement
Density Cutoff affects liquid volume measurement. If the density value goes below Density
Cutoff, the volume flow rate is reported as 0. Density Cutoff does not affect gas standard
volume measurement. Gas standard volume values are always calculated from the value
configured for Standard Gas Density or polled value if configured for polled base density.
4.6

Configure temperature measurement

The temperature measurement parameters control how temperature data from the
sensor is reported.
4.6.1

Configure Temperature Measurement Unit

ProLink III
Field Communicator Configure > Manual Setup > Measurements > Temperature > Temperature Unit
Overview
Temperature Measurement Unit specifies the unit that will be used for temperature
measurement.
Procedure
Set Temperature Measurement Unit to the option you want to use.
The default setting is Degrees Celsius.
Options for Temperature Measurement Unit
The transmitter provides a standard set of units for Temperature Measurement Unit.
Different communications tools may use different labels for the units.
42
Device Tools > Configuration > Process Measurement > Temperature
Micro Motion Model 2500 Transmitters with Configurable Input/Outputs