Appendix A Default Values And Ranges; Overview; Most Frequently Used Defaults And Ranges - Emerson Micro Motion 2400S Configuration And Use Manual

Appendix A
Default Values and Ranges
A.1

Overview

This appendix provides information on the default values for most transmitter parameters. Where
appropriate, valid ranges are also defined.
These default values represent the transmitter configuration after a master reset. Depending on how
the transmitter was ordered, certain values may have been configured at the factory.
A.2

Most frequently used defaults and ranges

The table below contains the default values and ranges for the most frequently used transmitter
settings.
Table A-1 Transmitter default values and ranges
Type Setting
Flow Flow direction
Flow damping
Flow calibration factor
Mass flow units
Mass flow cutoff
Volume flow type
Volume flow units
Volume flow cutoff
Meter factors Mass factor
Density factor
Volume factor
Configuration and Use Manual
Default Range
Forward
0.64 sec 0.0–40.96 sec
1.00005.13
g/s
0.0 g/s
Liquid volume
L/s
0/0 L/s 0.0–x L/s
1.00000
1.00000
1.00000
Comments
User-entered value is
corrected to nearest lower
value in list of preset values.
For gas applications,
Micro Motion recommends a
minimum value of 2.56.
For T-Series sensors,this
value represents the FCF and
FT factors concatenated. See
Section 6.2.2.
Recommended setting is 5%
of the sensor's rated
maximum flowrate.
x is obtained by multiplying
the flow calibration factor by
0.2, using units of liters per
second.
131