Default Values And Ranges; Enable Access To The Off-Line Menu Of The Display; Disable Write-Protection On The Transmitter Configuration - Emerson Micro Motion 2700 Configuration And Use Manual

3.2

Default values and ranges

See Section E.1
parameters.
3.3 Enable access to the off-line menu of the
display
Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Display > Offline Variable Menu Features
Overview
By default, access to the off-line menu of the display is enabled. If it is disabled, you must
enable it if you want to use the display to configure the transmitter.
Restriction
You cannot use the display to enable access to the off-line menu. You must make a connection from
another tool.
3.4 Disable write-protection on the transmitter
configuration
Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Info Parameters > Transmitter Info > Write Protect
Overview
If the transmitter is write-protected, the configuration is locked and you must unlock it
before you can change any configuration parameters. By default, the transmitter is not
write-protected.
Configuration and Use Manual
to view the default values and ranges for the most commonly used
OFF-LINE MAINT > OFF-LINE CONFG > DISPLAY
ProLink > Configuration > Display > Display Options
Device Tools > Configuration > Transmitter Display > Display Security
OFF-LINE MAINT > CONFG > LOCK
ProLink > Configuration > Device > Enable Write Protection
Device Tools > Configuration > Write-Protection
Introduction to configuration and commissioning
21