Emerson Micro Motion 2500 Configuration And Use Manual page 144

Operate the transmitter with the Weights & Measures application
Table 10-5: Available actions when Approvals=NTEP
Function
Connecting from ProLink II, ProLink III, the
Field Communicator, or a host
Configuration
Calibration
Smart Meter Verification
External pressure and
temperature data
Testing and trimming out-
puts
Totalizers
Inventories
Sensor simulation
136
Unsecured
All supported connec-
tion types are availa-
ble.
Reading Allowed
Changing Allowed
Zero Allowed
Density Allowed
Temperature Allowed
Outputs set to Continue Allowed
Measuring
Outputs set to Fault Allowed
Outputs set to Last Allowed
Measured Value
Retrieved by polling Allowed
Written by Modbus or Allowed
HART host
mA output loop test Allowed
mA output trim Allowed
Frequency output loop Not allowed
test
Discrete output loop Allowed
test
Resetting Allowed. If any single
totalizer is reset, all
other totalizers are re-
set automatically.
Starting Not allowed
Stopping N/A
Resetting Not allowed
Allowed
Micro Motion Model 2500 Transmitters with Configurable Input/Outputs
Transmitter status
Secured
Physical security prevents access to the
RS-485 terminals, so neither RS-485
connections nor service port connec-
tions are available.HART/Bell 202 con-
nections can be used to read data from
the transmitter, but software security
prevents writing to the transmitter.
Allowed
Not allowed
Not allowed
Not allowed
Not allowed
Allowed
Allowed
Not allowed
Allowed
Not allowed
Not allowed
Not allowed
Not allowed
Not allowed
May or may not be allowed, depending
on configuration. Can be performed on-
ly if flow rate is zero. If any single totaliz-
er is reset, all other totalizers are reset
automatically.
N/A
Not allowed
Not allowed
Not allowed