Emerson Micro Motion 2500 Configuration And Use Manual page 224

Default values and ranges
Table C-1: Transmitter default values and ranges
Type Parameter
LSL
USL
MinSpan
Fault action
AO fault level – downscale
AO fault level – upscale
Last measured value timeout
LRV Mass flow rate
Volume flow rate
Density
Temperature
Drive gain
Gas standard volume flow rate
External temperature
External pressure
URV Mass flow rate
Volume flow rate
Density
Temperature
Drive gain
Gas standard volume flow rate
External temperature
External pressure
Frequency Tertiary variable
Output
Frequency factor
Flow rate factor
Scaling method
Frequency fault action
Frequency fault level – upscale
216
(continued)
Default Range
3
0.00 g/cm
3
10.00 g/cm
3
0.05 g/cm
Downscale
2.0 mA 1.0 – 3.6 mA
22 mA 21.0 – 24.0 mA
0.00 sec
−200.000 g/s
−0.200 L/s
3
0.000 g/cm
−240.000 °C
0.000%
−423.78SCFM
−240.000 °C
0.000 psi
200.000 g/s
0.200 L/s
3
10.000 g/cm
450.000 °C
100.000%
423.78 SCFM
450.000 °C
100.000 psi
Mass flow
1,000.00 Hz 0.001 – 10,000
Hz
1000 kg/min
Freq=Flow 0 or 0.5 –
277.5 ms
Downscale
15,000 Hz 10.0 – 15,000
Hz
Micro Motion Model 2500 Transmitters with Configurable Input/Outputs
Comments
Read-only.
LSL is calculated based on the
sensor size and characterization
parameters.
Read only.
USL is calculated based on the
sensor size and characterization
parameters.
Read-only.