Emerson Micro Motion 2500 Configuration And Use Manual page 127

Procedure
1.
2.
3.
4.
5.
6.
Configuration and Use Manual
Make a service port connection from ProLink III to your transmitter.
Choose Device Tools > Configuration > Weights & Measuresand set Regulatory
Agency to the apropriate regulatory agency for your application.
Option
NTEP
OIML
Choose Device Tools > Configuration > Totalizer Control Methods and set totalizer
control methods as desired.
Parameter
Reset Totalizers from Display
Reset Totalizers via Remote
Communications
Digital communications refers to any method that uses Modbus or HART
communications to interact with the transmitter. This includes ProLink III, the
Field Communicator, and any host.
If required for your installation, configure your transmitters for two frequency
outputs and set them to operate in Quadrature mode.
a. Choose Device Tools > Configuration > I/O > Channels.
b. For Channel B, set Channel Typeto Frequency Output and click Apply.
c. For Channel C, set Channel Typeto Frequency Output and click Apply.
d. Choose Device Tools > Configuration > I/O > Outputs > Frequency Output Mode
and select Quadrature.
If required for your installation, choose Device Tools > Configuration > Transmitter
Display > Display Security, then enable and configure a password for the alarm
menu.
Security for the alarm menu is required under German law for PTB-type approval for
gas applications.
If required for your installation, choose Device Tools > Device Information, then read
and record the firmware checksum values for the transmitter and the core
processor.
Set up the Weights & Measures application
Description
Regulatory agency for the U.S.A. and Canada
Regulatory agency for all other world areas
Option
• Enabled: You can reset totalizers from the display,
whether or not the transmitter is secured.
• Disabled: You can reset totalizers from the display only
when the transmitter is unsecured.
• Enabled: You can reset totalizers using digital communi-
cations, whether or not the transmitter is secured.
• Disabled: You can reset totalizers using digital communi-
cations only when the transmitter is unsecured.
119