Emerson Micro Motion 2500 Configuration And Use Manual page 116

Integrate the meter with the control system
Table 6-25: PVR-only HART process variables
Process variable
Volume Flow of Mix at Line
Volume Total Of Mix @ Line
Water Total @ Line
Table 6-26: TMR-only HART process variables
Process variable
Remediated Mass Flow
Remediated Mass Total
Remediated Mass Inventory
Table 6-27: PVR- and TBR-only HART process variables
Process variable
Unremediated Density
Table 6-28: PVR, TBR, and TMR HART process variables
Process variable
Total Remediated Time
Interaction of HART variables and transmitter outputs
The HART variables are automatically reported through specific transmitter outputs. They
may also be reported through HART burst mode, if enabled on your transmitter.
Table 6-29: HART variables and transmitter outputs
HART variable
Primary Variable (PV)
Secondary Variable (SV)
108
(continued)
Primary Varia-
ble (PV)
✓
Primary Varia-
ble (PV)
✓
Primary Varia-
ble (PV)
✓
Primary Varia-
ble (PV)
Reported via
Primary mA output
Secondary mA Output (if
present on your transmitter)
Micro Motion Model 2500 Transmitters with Configurable Input/Outputs
Secondary Third Variable
Variable (SV) (TV)
✓
Secondary Third Variable
Variable (SV) (TV)
✓
Secondary Third Variable
Variable (SV) (TV)
✓
Secondary Third Variable
Variable (SV) (TV)
Comments
If one assignment is changed, the other is changed auto-
matically, and vice versa.
If one assignment is changed, the other is changed auto-
matically, and vice versa. If your transmitter is not config-
ured for a secondary mA Output, the SV must be config-
ured directly, and the value of the SV is available only via
digital communications.
Fourth Varia-
ble (QV )
✓
✓
✓
Fourth Varia-
ble (QV )
✓
✓
✓
Fourth Varia-
ble (QV )
✓
Fourth Varia-
ble (QV )
✓