Emerson Micro Motion 2500 Configuration And Use Manual page 77

Table 5-2: Status alerts and Status Alert Severity
Alert code Status message
A023 Internal Totals Corrupt
(Core Processor)
A024 Program Corrupt (Core
Processor)
A025 Boot Sector Fault (Core
Processor)
A026 Sensor/Transmitter Com-
munications Failure
A027 Security Breach
A028 Core Processor Write Fail-
ure
A031 Low Power
A032 Meter Verification in Pro-
gress: Outputs to Fault
A033 Insufficient Right/Left Pick-
off Signal
A034 Meter Verification Failed
A035 Meter Verification Aborted Fault
A100 mA Output 1 Saturated
A101 mA Output 1 Fixed
A102 Drive Overrange
A103 Data Loss Possible (Totals
and Inventories)
A104 Calibration in Progress
A105 Slug Flow
A106 Burst Mode Enabled
A107 Power Reset Occurred
Configuration and Use Manual
(continued)
Default severity Notes
Fault
Applies only to flowmeters with the
standard core processor.
Fault Applies only to flowmeters with the
standard core processor.
Fault Applies only to flowmeters with the
standard core processor.
Fault
Fault
Fault
Fault Applies only to flowmeters with the
enhanced core processor.
Varies Applies only to transmitters with
Smart Meter Verification.
If outputs are set to Last Measured
Value, severity is Info. If outputs are
set to Fault, severity is Fault.
Fault
Applies only to flowmeters with the
enhanced core processor.
Fault
Applies only to transmitters with
Smart Meter Verification.
Applies only to transmitters with
Smart Meter Verification.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational
Applies only to flowmeters with the
enhanced core processor.
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Normal transmitter behavior; oc-
curs after every power cycle.
Configure device options and preferences
Configurable?
No
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
69