Grease Replenishment/Exchange For U-Axis Speed Reducer; Grease Replenishment; Grease Exchange - YASKAWA MOTOMAN-MPL80 II Instructions Manual

II
MPL80

9.3.4 Grease Replenishment/Exchange for U-Axis Speed Reducer

Fig. 9-7: U-Axis Speed Reducer Diagram
Grease inlet
Hexagon socket head
plug PT1/8

9.3.4.1 Grease Replenishment

9 Maintenance and Inspection
9.3 Grease Replenishment/Exchange
Fig. 9-6: U-Arm Posture
(Refer to Fig. 9-7 "U-Axis Speed Reducer Diagram".)
1. Make the U-arm horizontal to the ground.
2. Remove the hexagon socket head plug PT3/8 from the grease
exhaust port.
3. Remove the hexagon socket head plug PT1/8 from the grease inlet.
• If grease is injected with the bolt on, grease will leak inside
the motor and may cause a damage. Make sure to
remove the bolt before the grease injection.
NOTE
• Do not install a joint, a hose, etc. to the grease exhaust
port. Failure to observe this instruction may result in
damage to the motor due to coming off of an oil seal.
4. Install the grease zerk PT1/8 to the grease inlet. (The grease zerk is
delivered with the manipulator.)
5. Inject grease through the grease inlet using a grease gun.
– Grease type:
– Amount of grease:
– Air supply pressure of grease pump:
– Grease injection rate:
9-12
U-arm
U-axis speed reducer
Molywhite RE No. 00
140 cc
(280 cc for 1st supply)
0.3 MPa or less
8 g/s or less
HW1482870
170904-1CD
Grease exhaust port
Hexagon socket head
plug PT3/8
60 of 81