Rigid Surface Spray Paint Process - Geely EC718 2009 Workshop Manual

12-166 Paint/Coatings
EC718/EC718RV EC715/EC715RV 10/2009
4. Put the wool ball onto the surface, turn on the machine
with a speed at 2,500-3,000 r/ min.
Note
During operation, keep the machine stable and
move gently. Do not polish too deep. Do not polish
too long. Keep the polishing time as short as
possible, the polishing area as small as possible.
FE12-1050b
5. Firstly fully soak a sponge and squeeze excessive water.
Apply a small amount of polishing wax to the surface. Put
the sponge onto the surface, turn on the machine with a
speed at 2,500-3,000 r/min. Gently press the sponge to
polish for 3-5 s.
Note
During operation, keep the machine stable and
move gently. Do not work too long to avoid
overheating, as the paint will be damaged by the
heat.
FE12-1047b

12.13.4.4 Rigid Surface Spray Paint Process

Use the front fender as an example to explain the local
paint spray process.
Note
All rigid surface paint repairs must comply with Geely
standards. Confirm the repair area and choose the repair
techniques, such as local repair, block repair and the
whole vehicle repair. If it is a collision repair, according
to the sheet metal damage carry out sheet metal repair
or replacement the parts and then carry out painting.
Body, Sheet Metal and Painting