Fuel Filler Cap Release Handle Replacement - Geely EC718 2009 Workshop Manual

Body, Sheet Metal and Painting
2 1
FE12-0140b
2
FE12-0141b
FE12-0142b
12.3.3.8 Fuel Filler Cap Release Handle
Replacement
Removal Procedure:
1. Remove the driver electric seat. Refer to
Electric Seat Replacement.
2. Remove the driver door and the left rear door sill
nameplate. Refer to
Nameplate Replacement.
3. Remove center pillar lower trim panel. Refer to
12.9.1.4 Center Pillar Trim Panel
4. Remove the rear seat back bolster. Refer to
Seat Armrest Assembly
5. Lift the car carpet and remove the fuel filler cap release
handle retaining bolts.
6. Remove the rear compartment trim panel. Refer to
12.9.1.9 Rear Compartment Trim Panel
7. Disconnect the fuel filler cap release cable (1) from inside
the vehicle.
Note
Rotate the fuel filler door lock actuator counter
clockwise to loose the cable (1), and then pull the
cable out of the fuel filler door lock actuator (2).
8. Remove the fuel filler door lock actuator (2).
9. From the driver side, pull the fuel filler cap release cable
with the handle out of the vehicle.
Installation Procedure:
1. Install and tighten the fuel filler cap release handle
retaining bolts.
Torque: 10 Nm (Metric) 7.4 lb-ft (US English)
2. Route the release cable.
Note
Route the release cable the same as before
removal.
EC718/EC718RV EC715/EC715RV 10/2009
Body Rear End
11.11.8.1 Front
12.9.1.2 Left and Right Door Sill
Replacement.
12.7.3.6 Rear
Replacement.
Replacement.
12-25