Host Computer - Honeywell H-S81-HS Operation Manual

Configuration
Mode
• Reduced:
• Complete:
Baud Rate:
Data Bits:
Stop Bits:
Parity:
Handshake:

Host Computer

By selecting this option, a sub-menu will be accessed where the communication parameters of the
Host computer peripheral device can be configured, as shown in the picture below:
In order to change the parameters use the Up/Down buttons. Press Esc to exit and go back to the
previous menu. Below are the allowed field values and their meaning:
Host
• Disab.:
• Enabl.:
ID
Baud Rate
Data Bits
Stop Bits
Parity
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
To configure the printing mode in the operating cycle.
Only alarmed/activated events and fault conditions are printed;
All events are printed.
To configure the bit rate of the serial port. (Allowed values: 1200, 2400, 4800, 9600, 19200).
To configure the data bit number of the serial communication. Allowed values are: 7 and 8.
To configure the stop bit number of the serial communication. Allowed values are: 1 and 2.
To configure the parity control of the serial communication. Allowed values are: No (no parity),
Odd (off parity) and Even (even parity).
To configure the handshake type of the serial communication. Allowed values are: Xon/Xoff,
Rts/Cts, and None.
Figure 7.20 Host Computer
Host computer peripheral device with serial protocol disabled.
Host computer peripheral device with serial protocol enabled.
Identification of control panel number if several systems are to be centralized. It must be a
progressive number from 1 to 99. This parameter is used by both the serial communication
protocol and by the TCP/IP communication protocol.
To configure the bit rate of the serial port. (Allowed values: 1200, 2400, 4800, 9600, 19200).
To configure the data bit number of the serial communication. Allowed values are: 7 and 8.
To configure the stop bit number of the serial communication. Allowed values are: 1 and 2.
To configure the parity control of the serial communication. Allowed values are: No (no parity),
Odd (off parity) and Even (even parity).
Operating Instructions
143