Opc Server; Programming - Honeywell H-S81-HS Operation Manual

OPC Server

1.8 OPC Server
Thanks to the program OPC Server, any Windows OPC Client applications (Scada/DCS, supervi-
sors, control or other applications) can communicate to H-S81-HS series control panels featuring
V2.0.0 or higher software version. The OPC Client application can interact with all variables made
available by the control panel following the modes defined by the OPC standard. By using the pro-
gram OPC Server, clients can access the following data:
• Alarms
• Analog value measurements
• Device status indications
• Control panel status indications
• Communication status indications
For using the program OPC Server, please refer to the specific manual ST-057-IT.

1.9 Programming

H-S81-HS system programming is carried out through a personal computer in OFF-LINE mode by
means of a specific configuration program. After completing the configuration and checking that
the entered data are correct, data can be transferred to the central unit. Once they have been trans-
ferred, the central unit replaces the old configuration with the new one and re-initializes the system.
If there are two CPUs, the configuration is transferred to both at the same time. For using the con-
figuration program Pro-S81, please refer to the specific manual ST-015-IT.
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Figure 1.10 Example of Connection with OPC Server
General Description
25