9: S81-F6001-1; Description; Technical Features; Status Indications - Honeywell H-S81-HS Operation Manual

I/O modules
2.4.9 S81-F6001-1

Status Indications

The front panel includes 8 status LEDs with the following functions:
LED
Activated (Red LED)
Relised (Red LED)
Fault (Yellow LED)
Disabled (Yellow LED)
Inhibit (Yellow LED)
Hold (Yellow LED)
Aut. Off (Yellow LED)
Res. Bank (Yellow LED) Steady on when the reserve bank is selected

Virtual channels

The module controls the following variables:
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015

Description

This module is used for controlling the logic and indications of a certain fire
extinguishing zone in compliance with the requirements of the EN12094-1 stan-
dard. It controls ten output variables and seven input variables. It controls some
fire extinguishing system typical logics, such as discharge delay and reset inhibit
time. This module checks the status of the inputs and outputs physically located
on other modules by using virtual channels.

Technical Features

• Safety rating:
• Redundancy:
• Max. output current
• Automatic output protection:
• Supply voltage:
• Quiescent current:
• Operating temperature:
• Storage temperature:
• Maximum humidity:
• Hot swap capability:
Indication
Steady on under "activated" condition. It goes out in case of reset.
Steady on under "released" condition. It goes out in case of reset.
Flashing in case of trouble in the fire extinguishing zone.
Steady on if a fire extinguishing zone is disabled
Steady on under "inhibit" condition.
Steady on under "Hold" condition.
Steady on under "Automatic exclusion" condition
Variable Type Description
V1 In "Activated" condition
V2 In Main primary discharge
V3 In Reserve primary discharge
V4 In Main secondary discharge
V5 In Reserve secondary discharge
V6 In Intermittent audible indications
V7 In Continuous audible indications
V1 Out Manual activation
V2 Out Automatic activation
V3 Out Automatic exclusion
V4 Out Emergency hold
V5 Out Release inhibition
V6 Out Reserve bank
V7 Out Secondary discharge
V8 Out Triggered system
V9 Out General trouble
V10 Out General disable
Parts of the H-S81-HS System
applicable up to SIL3
Yes
250mA
No
22-29VDC
10mA
-5 - 50 °C
-30 - 80 °C
95% (RH) non-condensing
yes
69