Event Displaying
If during initialization a system fault is detected -e.g. a faulty module- the local buzzer will be acti-
vated intermittently, whereas the display will show the type of fault as shown in the following pic-
ture.
By pressing Enter, the control panel will carry out the following operations:
•
The "General trouble" LED flashes.
•
The "System Trouble" LED flashes.
•
The relays, General and System Trouble, are deactivated.
By selecting not to continue by using the arrows, the control panel will stop and remain stopped
until it is started again.
7.11.1 Disabled Condition
When a device is disabled, the control panel carries out the following operations:
•
The General Disable LED lights up steadily.
•
The Device Disable LED lights up steadily.
•
The Sounder Disable LED lights up steadily. (Only if the output type is Sounder)
The General Disable relay activates.
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Figure 7.24 Initialization
Figure 7.25 System Fault
Operating Instructions
147