Configuration - Honeywell H-S81-HS Operation Manual

Parts of the H-S81-HS System

Configuration

By using the configuration program ProS81, the following parameters can be set for each point of
the single devices, according to the relevant type:
Parameter
Operating mode
Sensitivity
Measuring range
Pre-alarm threshold
Alarm threshold
Type of indication
Automatic alarm reset
Operating mode
Timing
Output type
Sounder tone
Sounder volume
Enable/Disable status export to
Hosts
Enable/Disable commands
from Hosts on the channel
The following measuring ranges, with the relevant thresholds, can be selected for the 4-20mA
S81-Mod-AN module:
Field Connections
The module can be connected to field terminal block by using a flat or a multi-conductor cable,
depending on the used bus type.

S81-E2001-1 Bus
The module is connected to a S81-T8003-1 termination module with 8 terminals
with a 20-way flat cable.
74
Type Mode
Sensors Latching-NO, Latching-NC, Non-Latching-NO, Non-Latching-NC
Sensors 3 sensitivity levels to be selected
Sensors See table
Sensors According to the selected measuring range
Sensors According to the selected measuring range
Sensors Fire, Supervisory, Gas, Trouble, Hidden, Buzzer Only
Sensors Yes/No
Actuators Continuous-Normally Energized, Continuous-Normally De-energized,
Intermittent, Pulsing
Actuators 1 to 15 seconds (only for pulsing and intermittent modes)
Actuators Normal / Sounder
Actuators 7 selectable tones
Actuators 50,55,60,70,78,80,85,88,90,93,94,95,98 decibels
Sensors/Actuators No, TCP1, TCP2, RS232
Sensors/Actuators No, TCP1, TCP2, RS232
Measuring
range
0-10 ppm
0-20 ppm
0-50 ppm
0-100 ppm
0-200 ppm
0-100% LEL
0-25% O
2
15-25% O
2
4-20 mA
0-100°C
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Pre-alarm
Alarm Threshold
Threshold
0.0-10.0 0.0-10.0
0.0-20.0 0.0-20.0
0-50 0-50
0-100 0-100
0-200 0-200
0-100 0-100
0.0-25.0 0.0-25.0
15.0-25.0 15.0-25.0
4.0-20.0 4.0-20.0
0-100 0-100
I/O modules