4: Local Sounder; Management; 1: Loop Reset - Honeywell H-S81-HS Operation Manual

Operating Instructions
7.7.4 Local Sounder
Select this option to enable/disable the local sounder.
NOTE: In compliance with the EN12094-1 standard, no disabling is possible in fire extinguishing
zones during the discharge activation sequence.

7.8 Management

By selecting this option from the main menu, the "management" stage is accessed, as shown in the
picture below.
7.8.1 Loop Reset
Select this option to reset the loop for S81-F7002 and S81-F7007 type modules. If the module does
not exist, or is of a different type, an error message is displayed. Loop reset is required to reset a
short circuit condition or to temporarily remove the Logon Fault signal.
7.8.2 Date and Time Changing
By selecting this option, the system date/time setting page is displayed. This step allows to change
the various parameters. If the entered value is not allowed, an error message is displayed.
138
Figure 7.12 Management Menu
Figure 7.13 Changing Date/time
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Management