Tcp-Ip - Honeywell H-S81-HS Operation Manual

Operating Instructions
Handshake To configure the handshake type of the serial communication. Allowed values are: Xon/Xoff,

TCP-IP

By selecting this option, a sub-menu will be accessed where the communication parameters of the
TCP/IP protocol can be configured, as shown in the picture below:
In order to change the parameters use the Arrow and Number keys and confirm pressing Enter.
Press Esc to exit and go back to the previous menu. Below are the allowed field values and their
meaning:
Host
Com. Host
Host Port
Network Port
Panel IP
Master 1 IP
Master 2 IP
Gateway IP
Netmask
NOTE: Values 127.000.000.001 and 000.000.000.000 mean that the relevant function is disabled.
144
Rts/Cts, and None.
Figure 7.21 TCP/IP
To enable/disable Host TCP/IP communication protocol.
To define if the TCP/IP Host is redundant or not.
To define the communication port used by the TCP/IP Host.
To define the communication port used by the TCP/IP Network protocol.
To identify panel IP address.
To identify Host-1 IP address.
To identify Host-2 IP address.
To identify the IP address of the access point to geographical networks (VAN).
To define the range of a host in an IP network in order to reduce network traffic and simplify
the research of a certain IP address.
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Configuration