Cp 1616 Onboard; Installing The Raid Controller Software; Bios Update - Siemens SIMATIC HMI IPC677C Operating Instructions Manual

11.9.11

CP 1616 onboard

NDIS device driver
Read the information in description provided by Device_Driver_CP16xx.pdf on the supplied
"Documentation and Drivers" CD.
PROFINET IO
Read the information regarding the SIMATIC devices and SIMATIC NET documentation
listed in the "Integration" section.
11.10

Installing the RAID Controller software

You find the procedure for installing the RAID controller software in the RAID user manual on
the supplied "Documentation and Drivers" CD.
Note concerning Windows XP Professional
You need to select the Intel BD82QM57 Controller from the provided list when installing
Windows XP Professional for the first time.
11.11

BIOS update

Writing down the BIOS Setup settings
Before you update your BIOS Setup settings, you should write down the values so that you
can restore them after the BIOS update, if necessary.
Updating the BIOS default values
It is imperative that you update the BIOS default values after a BIOS update:
1. Keep the F2 key pressed during the device start until the setup menu is displayed on the
2. Load the defaults using F9.
3. Adapt the BIOS Setup settings again, if necessary.
Reboots
Several reboots can be carried out after a BIOS update. These reboots are initiated by the
Management Engine (ME). The reboots are required by the ME to adapt itself to the changes
in the BIOS update.
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
screen.
Service and maintenance
11.10 Installing the RAID Controller software
161