Technical data
14.2 Ports and status displays
14.2
Ports and status displays
Ports
DVI-I
USB
PROFIBUS/MPI port
Transmission rate
Operating mode
Physical port
•
–
Memory address area
–
Interrupts
PROFINET
1)
For unambiguous labeling, the LAN ports are numbered on the enclosure. The operating system numbering may deviate
1)
from this.
Ethernet
2)
COM1
Compact Flash
Status displays
Control unit
Computer unit
*1
∗2
180
Port for external CRT / LCD monitor
External: 4x USB 2.0 on the port side
•
(max. 2 can be simultaneously operated as high current)
There are 3 USBs available internally: 1 x USB 2.0 high current + 1x USB 2.0 low
•
current on a 10-pin male connector, 1 x USB 2.0 low current for internal USB
stick/dongle
Front panel port: 1x USB 2.0 high current
•
1x USB 1.1 high current
9-pin sub-D socket
9.6 Kbps to 12 Mbps, configured per software
Electrically isolated:
Data lines A, B
•
Control lines RTS AS, RTS_PG
•
5 V supply voltage (maximum 90 mA)
•
grounded: Shielding of the DP12 connection line
RS485, electrically isolated (within SELV)
•
–
Configured automatically
–
Configured automatically
3x RJ45 connection, CP 1616 compatible onboard port based on ERTEC 400,
10/100 Mbps isolated
Wake on LAN and Remote Boot are supported
Ethernet 1: Intel 82577 L, capable of teaming
capable of AMT, supports jumbo frames up to 4088 bytes
Ethernet 2: Intel 82574 L, capable of teaming
supports jumbo frames up to 9014 bytes
Serial port, 9-pin Cannon plug
Slot for Compact Flash card
Power LED
•
Temperature LED
•
Ethernet LEDs
•
Optical drive LED
•
DVD/CD access (to CD drive if installed)
•
2 x7 segment display (for BIOS post codes)
•
2x two-color alarm LEDs
1x LED for Profinet (optional)
Electrical isolation within the safety extra-low voltage circuit (SELV)
LAN interfaces are numbered on the enclosure to provide unique identification. The
operating system numbering may deviate from this.
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04