Raid Systems; Onboard Raid System; Setting Up The Onboard Raid System In The Firmware (Create Volume) - Siemens SIMATIC IPC647E Operating Instructions Manual

5.4

RAID systems

5.4.1

Onboard RAID system

5.4.1.1

Setting up the onboard RAID system in the firmware (Create Volume)

If you ordered a device with an onboard RAID system, the onboard RAID system is pre-
configured by default.
The subsequent setup of an onboard RAID system is carried out in the firmware under "Create
Volume".
After setting up the onboard RAID system, it can be configured using the "Intel® Optane™
Memory and Storage Management" software.
Requirement
• The drives required for the onboard RAID system are built into the device, see information
under: "RAID1 system (Page 69)".
Procedure
1. Switch on the device or restart it.
2. To access the user interface of the firmware, press <Esc> and hold it down immediately after
switching on the device when the message "Press ESC for boot options" appears.
The firmware user interface opens. Here you have the following keys available for
navigation:
3. Use the arrow keys of the keyboard to select "Device Management" from the firmware
selection menu and confirm your selection.
To select and save settings, refer to the information on navigating in the firmware, see
above.
SIMATIC IPC647E
Operating Instructions, 09/2022, A5E52254141-AA
Action
• Select entry
(then confirm selection)
• Confirm selection
Exception:
Confirm selection when integrating drives:
• Back to previous window
Navigation in the firmware
Key
• Arrow keys on the keyboard
• <Enter> key
Exception:
<Space> keyboard
–
• <Esc> key
Operating the device
5.4 RAID systems
71