Installation Of Windows 7 - Siemens SIMATIC HMI IPC677C Operating Instructions Manual

Service and maintenance
11.9 Reinstalling the software
11.9.3.3

Installation of Windows 7

Note
Specific information on the use of the Windows 7 operating system can be found in the
following manual (not included in the scope of delivery):
• Windows 7 Technical Reference (MS Press No. 5913)
Requirement
You need the Windows 7 recovery DVD, which is included in the scope of delivery.
Procedure
1. If necessary, connect a DVD drive to the USB interface.
2. Insert the Recovery DVD into the DVD drive.
3. Reboot the device.
4. Press the <F12> key when the following BIOS message appears.
5. In the boot menu, select the optical drive using the cursor keys. It is identified by a "P" in
6. Confirm the selection by pressing ENTER.
7. Immediately press any key when you see the following prompt to install the operating
8. Now follow the instructions in the installation program. You can find additional information
"Install Windows" installation program
The language of the installation program and the operating system you want to install has
been preset to English. You can change the language of the operating system after the
installation. You can find information on this in section: Auto-Hotspot.
152
Press F2 to go to Setup Ulility
Press F12 to go to Boot Manager
After initialization, a boot menu is displayed.
front of the SATA port number.
Example:
P3 - OPTIARC DVD-ROM DDU1681S
system from the Recovery DVD.
Press any key to boot from CD or DVD ..
After a few seconds, you will see the "Install Windows" installation program.
on this in the section: "Install Windows" installation program.
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04