Normal Operation; Switching On The Device - Siemens SIMATIC HMI IPC677C Operating Instructions Manual

8.2

Normal operation

8.2.1

Switching on the device

Requirement
● The peripheral devices are connected.
● The operating system and the service packs have been installed and set up on the hard
● The pre-installed drivers and applications have been set up appropriately. Further
● The proper ambient and environmental conditions according to the specifications for the
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
NOTICE
To comply with the EMC guideline of the device with I/O, ensure that the manufacturer
or supplier of the components used guarantees compliance with the regulations.
Connect the I/O devices via shielded cables with metal connectors. In doing so, the
shield must be connected over a wide area with the metal connector and the connector
must be firmly connected with the device housing.
disk of the device. Refer to the "Commissioning" chapter for more information.
information is available in the "Operation and configuration" chapter in the section,
"Additional drivers and applications."
device and the connected I/O modules have been observed.
Operation and configuration
8.2 Normal operation
79